I modified my APEX Controller’s email alarm setting today. 🙂 By default there is some code to notify if your temps fall above or below a certain range. There isn’t however code to tell you if one of your specific power bars/strips loses power. I found this out yesterday as the breaker had flipped to one of the power bar’s electrical source. Everything runs normal expect what’s plugged into that power bar. The controller will however email you if the whole system/brain loses power. So, I added the following code (in green) to the email alarm outlet so that I may be notified if there is a power failure to any of the plugged in power bars. EB8’s are Energy Bar 8 plugs.